Manifold Pressure/Vacuum Sensor: Service and Repair

13 62 010 - Removing and installing/replacing differential pressure sensor (N62TU)





Necessary preliminary tasks:
- Read out fault memory of Digital Motor Electronics (DME) control unit; if necessary, work through test schedules
- Switch off ignition
- Remove intake air manifold

Note:
Installation location:
- On rear side of intake air manifold.





Release screws.
Tightening torque 13 62 1AZ 13 62 Senders for Control Unit.
Pull differential pressure sensor (1) out of intake air manifold.





Installation:
Now clear the fault memory.