Fluid Pan: Service and Repair

24 11 010 Removing and installing/sealing or replacing gearbox sump (GA6HP26Z)





Important!
Remove gearbox sump only after it has cooled down.
After completion of work, check gearbox oil level.
Use only the approved gearbox oil.
Failure to comply with this requirement will result in serious damage to the automatic transmission!





Release screws (1).

Remove air deflector (2).

Tightening torque 24 00 6AZ.

Remove oil drain plug (1).





Tightening torque: 24 11 6AZ.

Drain automatic transmission oil.

Installation note:
Replace oil drain plug.





Recycling:
Catch and dispose of escaping gearbox oil.
Observe country-specific waste disposal regulations.





Unscrew all bolts.

Remove gearbox sump (1).

Installation note:
Insert screws (2) until screw heads make contact.

Insert all further screws in diagonal sequence from inside to outside until screw heads make contact.

Tightening torque: 24 11 5AZ.

Remove gasket (1) from gearbox sump.





Clean gearbox oil sump to remove residual oil.

Clean sealing surfaces with a cloth.

Place new seal on gearbox oil sump.

Important!
Do not degrease gearbox sump with cleaning agent.

oږF�: