32 41 311 Replacing Intake Pipe For Hydraulic Steering

32 41 311 - Replacing suction line for power steering (M57T2)





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.





Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove front underbody protection Removing and Installing / Replacing Front Assembly Underside Protection
- Remove oil reservoir Service and Repair





Expose suction line up to connection on vane pump.





Unfasten hose clip (1).
Detach suction line (2) from vane pump.

Installation Note:
When installing the suction line, make sure it is laid without tension and there is a sufficient gap to the adjacent components.
Identification (P) of suction line (2) and rib (3) of vane pump serve as an approximate guide to alignment.





After installation:
- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering Unit
- Check pipe connections for leaks