51 47 030 Removing and Installing/Replacing Rear (Inside) Left or Right Entrance Cover Strip

51 47 030 - Removing and installing/replacing rear (inside) left or right entrance cover strip

Special tools required:

Version without 3rd seat row:

Detach mucket (1) in area of entrance cover strip (2).

Release entrance cover strip (2) at retainer (3) and clips (4) towards top.

Installation:
If necessary, replace faulty retainer (3).

If necessary, release clips (4) from vehicle.

Installation:
Lug (1) must not be damaged or missing.

If necessary, replace faulty clips (2).

Fit missing clips on entrance cover strip (3).

Fit entrance cover strip (3) with preinstalled clips (2).

Version with 3rd seat row:

Detach mucket (1) in area of entrance cover strip (2).

Release entrance cover strip (2) at retainer (3) and clips (4) towards top.

Installation:
If necessary, replace faulty retainer (3).

If necessary, release clips (4) from vehicle.

Using special tool 00 9 317, raise trim panel (1) slightly and unclip from retainer (3).

Pull entrance cover strip (4) in direction of arrow out of clip (2).

Installation:
If necessary, replace faulty retainer (3).