24 14 002 Replacing Shaft Seal For Selector Shaft (GA6HP19Z)

24 14 002 - Replacing shaft seal for selector shaft (GA6HP19Z)





Special tools required:





Important!
After completion of work, check transmission fluid level Procedures.

Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Remove underbody protection [1][2]51 47 491 Removing and Installing/Replacing Rear Underbody Protection





Unfasten nut.

Remove cable (1).

Installation Note:
Adjusting cable:

- Release nut
- Adjust cable by means of holder (2)
Distance A ≥ 1.5 mm.





Unfasten nut.

Take off holder (1).

Tightening torque 24 51 1AZ [1][2]Shift Linkage, A/T.





Screw in special tool 24 5 361 24 5 360 Fixture until it is firmly connected with shaft seal.





Screw special tool 24 5 362 24 5 360 Fixture onto special tool 24 5 361 24 5 360 Fixture and tighten down.

This pulls the shaft seal out of the transmission housing.





Oil sealing lip on shaft seal (1).

Screw in shaft seal (1) with special tools 24 5 366 24 5 360 Fixture and 24 5 364 24 5 360 Fixture as far as it will go.