24 34 562 Replacing Mechatronics (GA6HP19Z TU)
24 34 562 Replacing mechatronics (GA6HP19Z TU)Special tools required:
Note:
After completing work:
^ Load specific data version with DIS
Important!
After completion of work, check transmission oil level.
Use only approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Important!
Read and comply with notes on protection against electrostatic damage (ESD protection).
Necessary preliminary tasks:
^ Remove underbody protection at front and rear
^ Remove exhaust system bracket
Remove plates (2).
Unfasten nut.
Disconnect cable (1).
Installation:
Adjusting cable:
^ Release nut
^ Adjust cable by means of holder (2) until spacing A ≥ 1 mm is obtained.
^ Tighten down nut
Secure lever (1) with a cable tie (2) or wire in vertical position.
Important!
Mechatronics can be destroyed by static discharges. Therefore the contacts inside the plug must not be touched. Insert special tool immediately after work step.
Unscrew plug (1) and disconnect.
Insert special tool 24 2 390 in sealing sleeve (1).
Remove transmission oil sump.
Unlock sealing sleeve with slide (1).
Note position of sealing sleeve.
Pull out sealing sleeve (1).
Installation:
Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.
Lug on sealing sleeve must not be damaged!
Note:
GA6HP19Z TU
Release all screws (1 and 2).
- 1 = M6 x 59 mm
- 2 = M6 x 20 mm
Remove mechatronics.
Installation:
Check gaskets (1 and 2) for damage, replace gaskets if necessary.
Coat new seals with automatic transmission fluid and install.
Installation:
Insert screws (3) alternately until contact is made with each screw head.
Insert all further screws contact is made with each screw head.
Note:
GA6HP19Z TU
Important!
Tighten down screws in order 1...13.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Tightening torque 24 30 1AZ.
