Sunroof / Moonroof Panel: Service and Repair

54 12 115 Removing And Installing Glass Slide/Tilt Sunroof Cover







Necessary preliminary work:
- Remove gaiter on left and right







Installation note:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of hardening)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Release left and right screws (1).
Remove glass slide/tilt sunroof cover (2) towards top.

Installation note:
Replace screws (1).
Insert screws (1) but do not tighten down yet.

Adjust and initialise glass slide/tilt sunroof cover.