112501 - P0205 (DME)

112501 - P0205

Information saved in
DME

Fault code
112501 - P0205

Fault text
Injector, cylinder 5, activation: open circuit

Fault description
The diagnostic function monitors electrical activation of the
injector.

Condition for fault identification
Test condition:
The fault is recognized when the voltage at the injector is >
210 V and the injector's electrical charge is < 300 microamps.
Potential problem source(s):
- Defect in wiring harness between DME and injector 5
- Injector 5 defective
Terminal condition: none
Voltage condition:
- Electrical system voltage > 10 V
Temperature condition:
- Coolant temperature > -20 °C
Time condition:
- None
Other conditions:
- Engine on

Condition for fault memory entry
This fault is logged in the control module's fault memory
immediately.

Action in service
- Inspect wiring harness between DME and injector 5
- Check injector 5: Measure the resistance between the pins
for the injectors, (specified: 200 kOhm +/-10 kOhm), if the
specified value is not obtained, replace the injector

Fault effect and breakdown warning
Breakdown notice:
- The engine reverts to its limp-home program, continued
vehicle operation is possible but drivability is restricted,
because power is reduced the driver should refrain from
passing maneuvers.
Possible apparent symptoms:
- Engine runs poorly with power loss

Driver information
Warning light:
- ECE emissions warning lamp: on
- US emissions warning lamp: on
- ECE electronic engine power reduction: on
- US electronic engine power reduction: on
- CC message: "Engine malfunction, loss of power"

Service instruction
- none