27 10 070 Replacing Output Flange on Transfer Box at Rear (ATC350)

27 10 070 Replacing output flange on transfer box at rear (ATC350)





Important!
After completing work, check transmission oil level and top up if necessary.
Use only the approved transmission oil.





Note:
^ Replace output flange only together with a new radial shaft seal.
^ Procedure for removing output flange is identical to replacing radial shaft seal.





Installation note:
^ Thickness of new shim must be determined before output flange is installed.

Determine and note down dimension A of output flange (previous and new).





Determine and note down dimension B of output flange (previous and new).





Determine dimension C, thickness of shim.





Installation note:
Calculate thickness of new shim:

1. Add dimension A of output flange (previous) and dimension C of shim (previous)
Then subtract dimension B (previous) from result A+C (previous)
2. Subtract dimension B from dimension A of output flange (new)
3. Then subtract result of step 2 from result of step 1.