Removing And Installing/Replacing Pressure Lines For Oscillating Motor (RA1/RA2)
37 13 132 - Removing and installing/replacing pressure lines for oscillating motor (RA1/RA2)
Special tools required:
- 32 1 270
Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!
Scalding hazard!
This work may only be carried out on an exhaust system which has cooled down.
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Seal off line connections with plugs 32 1 270 .
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Necessary preliminary tasks:
- Lower rear axle 33 31 503 Lowering/Raising Rear Axle Carrier
Release banjo bolts (1).
Tightening torque 37 13 5AZ 37 13 Hydraulic Lines.
Hydraulic lines must be provided with suitable sealing plugs 32 1 270 immediately after removal!
Release screws (1) from holder on rear axle carrier.
Release screws (1) and remove pressure lines from oscillating motor.
Pressure lines and connections on oscillating motor must be fitted with suitable sealing plugs 32 1 270 immediately after removal!
Tightening torque 37 13 4AZ 37 13 Hydraulic Lines.
Important!
When assembling, make sure that in succession only the sealing plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.
After installation:
- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering (Version With Dynamic Drive)
- Check line connections for leaks
- Carry out initial Dynamic Drive operation 37 10 001 Initial Operation With Test Run of Dynamic Drive.