32 41 421 Replacing Expansion Hose Part 2 (With ARS) (From T-Piece to Power Steering Gear)
32 41 421 Replacing expansion hose part 2 (with ARS) (from T-piece to power steering gear) N63Special tools required:
Warning!
Danger of poisoning if oil is ingested/absorbed through the skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Do not draw off hydraulic fluid (risk of contamination).
Close off pipe connections with plugs.32 1 270
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Necessary preliminary tasks:
^ Lower front axle support
Important!
Pressure line and connections must be provided with suitable plugs 32 1 270 immediately after removal!
Release screw (1) from line flange.
Tightening torque 37 13 8AZ.
Release holder (2).
Release block screw connection (1) on steering gear.
Tightening torque 32 41 5AZ.
Remove hydraulic line.
Important!
When assembling, make sure that in succession only the sealing plugs of the line to be fitted are removed.
When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.
Do not replace sealing rings on hydraulic lines.
Replace affected line if sealing ring is damaged.
After installation:
^ Fill and bleed hydraulic system
^ Check line connections for leaks
^ Carry out initial Dynamic Drive operation
�d� =�� :
Pu� :
