26 11 052 Replacing Flexible Disc For Rear Propeller Shaft

26 11 052 Replacing flexible disc for rear propeller shaft





Necessary preliminary work:
^ Remove propeller shaft from rear axle final drive and centre mount

Note:
To protect universal joints, tie back propeller shaft in area of centre mount.





Important!
Before removing propeller shaft:
The three-hole flange to the rear axle final drive is balanced with the propeller shaft.
The three-hole flange and the propeller shaft must be reassembled in the same position.
Mark three-hole flange (1), flexible disc (2) and propeller shaft (3) in one plane.





Release screws and remove flexible disc (1) from propeller shaft.
Important!
Replace ZNS bolts and self-locking nuts.

Tightening torque and angle of rotation 26 11 4AZ.

Installation note:
- During installation arrows (2) on circumference of flexible disc must point to flange arms (3).





Installation note:
Check centering mount.

Replace damaged centering mount.

Important!
Plastic centering mount must not be greased.

�O#: