Removing And Installing/Replacing Underfloor Pressure Lines For Oscillating Motor (RA1/RA2)

37 13 130 - Removing and installing/replacing underfloor pressure lines for oscillating motor (RA1/RA2)





Special tools required:
- 32 1 270





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!

Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.

Do not draw off hydraulic fluid (risk of contamination).

Seal off line connections with plugs 32 1 270 .





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.





Necessary preliminary tasks:
- Remove right underbody panelling 51 71 015 Removing and Installing/Replacing Left or Right Underbody Panels





Important!
Pressure lines and connections on valve block must be fitted with suitable sealing plugs 32 1 270 immediately after removal!





Release screws (1) for hydraulic lines on valve block.

Tightening torque 37 13 3AZ 37 13 Hydraulic Lines.





Important!
Note installation position of spacers (1) and (2).

Failure to do so may result in noises/rattling!





Open holder (1) and remove pressure lines.

Installation Note:
If necessary, replace damaged holders.





Release banjo bolts (1).

Tightening torque 37 13 5AZ 37 13 Hydraulic Lines.

Hydraulic lines must be provided with suitable sealing plugs 32 1 270 immediately after removal!





Important!
When assembling, make sure that in succession only the sealing plugs of the line to be fitted are removed.

When fitting lines, do not tilt connectors (sealing rings!) and connect fully before screwing.

Do not replace sealing rings on hydraulic lines.

Replace affected line if sealing ring is damaged.





After installation:

- Fill and bleed hydraulic system 32 13 006 Bleeding Power Steering (Version With Dynamic Drive)
- Check line connections for leaks
- Carry out initial Dynamic Drive operation 37 10 001 Initial Operation With Test Run of Dynamic Drive.