65 50 170 Removing and Installing/Replacing Cover For Central Information Display (CID, JC)

65 50 170 Removing And Installing/replacing Cover For Central Information Display (CID, JC)

Special tools required:







NOTE: These repair instructions apply to the Central Information Display (CID) of the manufacturer Johnson Controls (JC).







IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).







Necessary preliminary work:
- Remove Central Information Display







Release screws (1).
Tightening torque 65 50 2AZ

NOTE: To tighten screws, use special tool 00 9 460.

Remove rear cover (2) from Central Information Display (3).

Installation note:
Make sure rear cover (2) is correctly seated on Central Information Display (3).







IMPORTANT: Do not damage or scratch the display.

Carefully disconnect the plug connection (1) (only F01, F02, F03, F04).

Carefully raise latch mechanisms (2) and remove Central Information Display (3) from Central Information Display cover (4).

Installation note:
Make sure latch mechanisms (2) are heard to click into place.

Make sure rear Central Information Display cover (4) is correctly seated on Central Information Display (3).
Ensure correct cable routing in guide (5).







IMPORTANT: Before/after assembly, cover is bolted to the Central Information Display, correct installation position must first be checked.







Installation note:
Before connecting the screw connection, check whether latch mechanisms marked with an arrow are correctly seated.







Installation note:
Before connecting the screw connection, check all-round rim at the places marked with an arrow.