51 14 110 Removing and Installing/Replacing Rear Model Designation

51 14 110 Removing And Installing/Replacing Rear Model Designation







IMPORTANT: The "Instructions for number/letter combination cementing" serve as the basis for these repair instructions and must be followed without fail.







Attach adhesive tape (1) to rear lid lower edge (2) up to top edge "B". Mark measurement "A" from outermost corner point of rear lid (2) on adhesive tape (1).

Dimensions for mounting start point (3):
A = 72.2 mm
B = 15.3 mm

NOTE: Measurements C, D, E and F are for information purposes only, as determined by carrier film.

C = 4.8 mm, D = 19.3 mm, E = 6.8 mm, F = 6.8 mm