65 11 075 Removing and Installing/Replacing DVD Changer

65 11 075 Removing And Installing/replacing DVD Changer







IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).







NOTE: Comply with notes and instructions on handling optical fibres.







Necessary preliminary tasks:
- F01/02: Disconnect battery earth cable.
- F03: Disconnect both battery earth cables
- Remove decorative strip on storage compartment/DVD changer instrument panel







NOTE:
Affects all vehicles from series introduction to 09/2009 with DVD changer (SA696).
When a new DVD changer (2) is being replaced (as of 09/09), conversion to ISTA/P must be carried out. ("Converting replacement DVD changer")
If the old DVD changer (1) is installed (up to 09/09), this conversion to ISTA/P must not be carried out.
The old DVD changer (1) and the DVD changer (2) have an external difference in that the Load and Eject buttons are swapped round.







Unclip trims (1) with a suitable tool and release screws behind.
Pull DVD changer (2) out of guide.
Unlock associated plug connection (3) and disconnect.
Remove DVD changer (2).







Replacement:
Carry out vehicle programming/coding.