67 62 020 Removing and Installing/Replacing Flat Motor For Rear Left or Right Power Window Unit

67 62 020 Removing and Installing/Replacing Flat Motor For Rear Left or Right Power Window Unit







Necessary preliminary tasks:
- Remove rear power window unit







Release screws (1) and detach flat motor (2) from power window unit.

Installation:
Retaining pins (3) must not be released.







IMPORTANT: To ensure tension-free installation of flat motor, observe the specified screwing sequence.

Tighten first screw (1), then screw (2) and finally screw (3).
Tightening torque 67 62 1AZ.







After installation:
An initialisation must be carried out in order to activate anti-trapping protection.
Read and comply with notes on initialising power windows.