27 10 070 Replacing Output Flange on Transfer Box at Rear (ATC 350)

27 10 070 Replacing Output Flange On Transfer Box At Rear (ATC350)







IMPORTANT:
After completing work, check transmission oil level and top up if necessary.
Use only the approved transmission oil.







NOTE:
- Replace output flange only together with a new radial shaft seal.
- Procedure for removing output flange is identical to replacing radial shaft seal.

Installation note:
- Thickness of new shim must be determined before output flange is installed.







Determine and note down dimension A of output flange (old and new).







Determine and note down dimension B of output flange (old and new).







Determine old dimension C, thickness of shim.







Installation note:

Calculate thickness of new shim:

1. Add old dimension A of output flange (previous) and old dimension C of shim
Then subtract old dimension B from old result A+C
2. Subtract dimension B from dimension A of output flange (new)
3. Then subtract result of step 2 from result of step 1.