11 13 020 Removing and Installing/Replacing Lower Oil Sump Section

11 13 020 Removing and installing/replacing lower oil sump section (N63)





Necessary preliminary work:
^ Remove underbody protection at front and rear.
^ Release oil drain plug and drain engine oil.
^ Remove stiffening plate (all wheel drive vehicle, F12, F13).





Unlock plug connection (1) on oil level sensor and disconnect.

Release screws (2) along line.

Tightening torque 11 13 3AZ.

Remove lower oil sump section (3).

Installation note:
Clean sealing surfaces.

Replace gasket.

Replace screws.

When replacing lower oil sump section:

Convert oil level sensor.

Replace sealing ring.





Note:
Procedure with four-wheel drive.

Unlock plug connection (1) on oil level sensor and disconnect.

Release screws (2) along line.

Tightening torque 11 13 3AZ.

Remove lower oil sump section (3).

Installation note:
Clean sealing surfaces.

Replace gasket.

Replace screws.

When replacing lower oil sump section:

Convert oil level sensor.

Replace sealing ring.