24 11 011 Removing and Installing/Sealing or Replacing Transmission Sump (GA6HP19Z)

24 11 011 Removing and installing/sealing or replacing transmission sump (GA6HP19Z)





Important!
Remove transmission sump only after it has cooled down.
After completion of work, check transmission oil level.
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the automatic transmission!





Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste disposal regulations.





Necessary preliminary tasks:
^ Remove underbody protection





Remove oil drain plug (1).

Tightening torque: 24 11 2AZ.

Drain automatic transmission fluid.

Installation:
Replace oil drain plug.





Unscrew all bolts.

Remove transmission sump (1).

Installation:
Insert screws (2) until screw heads make contact.

Insert all further screws in diagonal sequence from inside to outside until screw heads make contact.

Tightening torque: 24 11 1AZ.





Remove gasket (1) from transmission sump.

Clean sealing faces and groove with a cloth.

Insert new gasket in transmission sump groove.

Important!
Do not degrease transmission sump with cleaning agent.





Replace sealing ring (1) on oil filter tube.





Installation:
The gasket is correctly installed when it is engaged in the locating opening of the transmission sump.