37 22 540 Replacing Air Supply Unit

37 22 540 Replacing The Air Supply System







IMPORTANT:
For FO7vehicles built until including 12/2010:
When replacing the air supply system, run "Converting the EHC replacement compressor" with the diagnosis system.







IMPORTANT:
Danger of injury.
Drain the air suspension system before carrying out any work on the air supply system, air pipes and air spring struts. Danger of injury if this instruction is not complied with.
Risk of damage.
Extreme cleanliness must be ensured at the connection face of the pipes during dismantling and installation. Even the smallest of dirt particles can cause leakage in the air suspension system.

NOTE: Read and comply with notes on air suspension system.







Necessary preliminary tasks:
- Deactivating air suspension system:
- Raise vehicle on lifting platform.
- Remove ignition key
- Pull out fuse for air spring system in luggage compartment at rear right







IMPORTANT: Do not kink, twist or crush pipes.







Release nuts and screws. Remove trim (1).







- Unlock plug
connections (1) and (2) and disconnect.
Carefully slacken banjo bolt (3) and (4) until the sound of escaping air can be heard

NOTE: Wait roughly 2 minutes until the pressure on the left side and/or right side of the air spring system is completely reduced (hissing sound stops).

Line (3), air spring strut, left: Red
Line (4), air spring strut, right: Blue

- Only fully release banjo bolt(s) after complete pressure reduction







Installation note:
- Replacement: Remove and dispose of screw connections on new air supply system.
Reuse screw connections on lines.

- Check banjo bolts for dirt, clean if necessary.
- Carefully screw in banjo bolts by hand to avoid damaging the plastic threads and with it air supply system.
Tightening torque 37 12 1AZ.







Unfasten plug connector (1) and disconnect.
Disconnect ventilation line (2).
Release nuts (3) and remove air supply unit.
Tightening torque 37 22 1AZ.







Activating and filling air spring system:
- Insert fuse in corresponding slot in fuse box
- Set vehicle down on its wheels
- Start engine
- Air spring system is automatically filled







After installation:
For F07vehicles built until including 12/2010:
When replacing the air supply system, run "Converting the EHC replacement compressor" with the diagnosis system.