Starter Motor: Service and Repair

12 41 020 Removing And Installing/Replacing Starter (N63)







Necessary preliminary tasks:
- Turn off ignition
- Disconnect battery negative lead
- Remove right engine support arm







Unlock plug (1) and remove.

Slacken nut (2).

Tightening torque 12 42 2AZ .

Detach starter positive cable.







Release screws (1).

Tightening torque 12 41 1AZ .

Disengage cable (2) from holder.

Pull out starter in direction of travel, feed out and remove.

Installation:
When replacing the starter, convert cable holder for cable (2).







Installation:
Check starter pinion and ring gear for damage. Replace damaged parts if necessary.

Reassemble the vehicle.