65 50 ... Replacing Cover For Central Information Display (CID, TPO)

65 50 ... Replacing Cover For Central Information Display (CID, TPO)







NOTE: These repair instructions apply to the Central Information Display (CID) of the manufacturer TPO.







IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).







Necessary preliminary work:
- Remove Central Information Display







Release screws at marked points.

Tightening torque 65 50 3AZ.

NOTE: To tighten screws, use special tool 00 9 460.

Remove brightness sensor cover (3).

Remove rear cover (1) of central information display (2).







Detach adhesive tape fixation (1).

Installation note:
A new adhesive tape is included with the replacement part delivery.

Disconnect plug connection (2).

IMPORTANT:
Risk of damage.

The wiring harness (4) can be crushed by the cover (3) at the position marked by the arrow.

Installation note:
The adhesive tape (1) of the wiring harness (4) must be applied before installation of the cover (3).







Release screws at marked positions.

Tightening torque 65 50 2AZ.

NOTE: To tighten screws, use special tool 00 9 450.

Feed out cable (2) and remove associated brightness sensor.

Installation note:
Check for correct cable routing and ensure that the brightness sensor is correctly seated and in the correct position.

Carefully raise latch mechanisms (1) and remove central information display cover (3).

Installation note:
Make sure latch mechanisms (1) are heard to click into place.

Make sure cover (3) is correctly seated on central information display.