11 61 068 Removing and Installing/Replacing Right Intake Manifold

11 61 068 Removing and installing/replacing right intake manifold (N63)





Necessary preliminary work:
^ Remove right injection pipe.
^ Remove throttle valve
^ Release screws on intake manifold from above without fail before lowering front axle
^ Secure engine in installation position
^ Lower front axle, releasing screws on engine mount first
^ Release A/C compressor and place to one side





Detach engine ventilation hose (1).

Disconnect plug.

Unscrew nuts (2).

Tightening torque: 11 61 1 AZ.

Remove throttle valve (2).





Release screw (1).

Tightening torque: 11 61 2 AZ.

Feed out intake manifold towards rear.

Installation Note:
Replace all profile seals.





Assemble engine and vehicle.

Check air intake system for leaks.