11 13 020 Removing and Installing/Replacing Lower Oil Sump Section

11 13 020 Removing and installing/replacing lower oil sump section (N63)





Necessary preliminary tasks:
^ Remove underbody protection at front and rear
^ Remove oil drain plug and drain engine oil.
^ Remove stiffening plate (fourwheel drive only)





Unlock plug connection (1) on oil level sensor and disconnect.

Release screws (2) along line.

Tightening torque 11 13 3AZ.

Remove lower oil sump section (3).

Installation:
Clean sealing surfaces.

Replace seal.

Replace screws.

When replacing oil sump bottom section:

Convert oil level sensor.

Replace sealing ring.





Note:
Procedure with four-wheel drive.

Unlock plug connection (1) on oil level sensor and disconnect.

Release screws (2) along line.

Tightening torque 11 13 3AZ.

Remove lower oil sump section (3).

Installation:
Clean sealing surfaces.

Replace seal.

Replace screws.

When replacing oil sump bottom section:

Convert oil level sensor.

Replace sealing ring.