41 11 031 Stripping Operations - Replacing Front Right Wheel Arch

41 11 031 Stripping operations - Replacing front right wheel arch







NOTE: Owing to the different engine variants and equipment specifications, not all the components are taken into consideration.

The following list basically represents the removal sequence.
- Disconnect battery negative lead (FR number: 61 20 900)
- Remove bumper trim (FR number:51 11 156
- Remove bumper carrier (FR number: 51 11 050)
- Remove headlight (FR number: 63 12 010)
- Remove radiator (FR number: 17 11 000)
- Remove A/C system condenser (FR number: 64 53 550)
- Remove and install intercooler (FR number: 17 51 000)
- Remove hydraulic steering cooling coil (FR number: 17 11 370)
- Remove intake silencer housing (FR number: 41 35 111)
- Remove coolant expansion tank (FR number: 17 11 100)
- Remove wheel arch cover (front section) (FR number: 51 71 038)
- Remove wheel arch cover (rear section) (FR number: 51 71 039)
- Completely remove and install front axle with engine and gearbox (FR number:31 10 001)
- Remove engine compartment lid seal mounting (FR number: 51 76 035)
- Remove engine compartment lid (FR number: 4161 000)
- Remove engine compartment lid hinge on right (FR number: 41 61050)
- Remove right side wall (FR number: 41 35 055)
- Remove top right wishbone (FR number: 31 12 003)
- Remove right suspension cross-brace (FR number: 51 71 346)
- Remove bulkhead sound insulation
- Remove heating A/C system blower (FR number:64 11 213
- Remove air conditioning refrigerant lines.
- Release right wiring harness
- Partially release/remove thermal protection







Release grommet (1) from fan housing and lay wiring harness (2) to one side.

Installation:
The sealant between grommet (1) and fan housing must be replaced.

Make sure rubber grommet (1) is correctly seated. (watertightness).