66 32 020 Removing and Installing/Replacing Sensor For Lane Departure Warning (HC2 Sensor)

66 32 020 Removing And Installing/replacing Sensor For Lane Departure Warning (HC2 Sensor)







Necessary preliminary tasks:
- Remove rear bumper trim







Unfasten plug connection (1) and disconnect.

Unlock catch (2).

Remove HC2 sensor (3) in direction of arrow from bracket.







IMPORTANT: If, in the event of side damage to the vehicle, it is not necessary to replace the rear apron, observe the following points:
- Mount middle bumper trim guide on undamaged side
- Use middle bumper trim guide as a gauge in order to check or correct the position of the remaining connecting points.
- Middle bumper trim guide must be able to be installed without tension.







Replacement:
- Carry out vehicle programming and encoding.








Replacement/after body repair:
-> Execute diagnosis job
- Initial operation
- SWW sensor system