24 14 001 Replacing Selector Shaft Seal (GA6HP26Z/6HP32Z)

24 14 001 - Replacing selector shaft seal (GA6HP26Z/6HP32Z)





Special tools required:






Important!
After completion of work, check transmission fluid level 00 11 500 Checking/Topping Up Fluid Level In Automatic Transmission (GA6HP26Z/GA6HP32Z).

Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
Remove underbody protection.





E65/M67TU only

Release screws.

Remove transmission underguard (1).

Remove left diesel particulate filter.





E65/N62 only:

Release screws.

Remove transmission underguard (1).

Remove left oxygen sensor.

E60/ E63/ E64, N62 only:

Remove rear underbody protection.

Remove left oxygen sensor (N62 only).





Note:
Version 1:

Unfasten nut.

Remove cable (1).

Installation Note:
Adjusting cable:

- Release nut
- Adjust cable by means of holder (2)
Distance A ≥ 1 mm.





Note:
Version 2:

Grip clamping sleeve (1) and slacken nut (2).

Tightening torque 25 16 2AZ [1][2]Shifter A/T.

Detach retainer (3) towards bottom using a screwdriver.

Pull cable (4) out of holder.

Installation Note:
Adjust selector lever Adjustments.





Note:
Version 3:

Release shift cable head (2) from ball head.

Installation Note:
Adjust selector lever.

Illustration similar.





Unfasten nut.

Take off holder (1).

Tightening torque 24 51 1AZ [1][2]Shift Linkage, A/T.

Note:
Illustration shows E65.





Screw in special tool 24 5 361 until it is firmly connected with shaft seal.





Screw special tool 24 5 362 onto special tool 24 5 361 and tighten down.

This pulls the shaft seal out of the transmission housing.





Oil sealing lip on shaft seal (1).

Screw in shaft seal (1) with special tools 24 5 366 and 24 5 364 as far as it will go.