32 41 311 Replacing Intake Pipe For Hydraulic Steering

32 41 311 - Replacing suction line for power steering (M57T2 335d)





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations





Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove front underbody protection Removing and Installing/Replacing Front Underbody Protection





Remove fluid reservoir from bracket 32 41 250 Removing and Installing/Replacing Fluid Reservoir For Power Steering.
Release hose clamp (1) and detach suction line (2) from fluid reservoir.

Installation Note:
Make sure suction line is laid without tension and with sufficient spacing to adjoining components.





Expose suction line up to connection on vane pump.






Important!
Cover alternator with a suitable covering to prevent ingress of hydraulic fluid.

Release hose clamp (1) and detach suction line (2) from vane pump.

Installation Note:
Markings (3) on suction line and vane pump must match up.





After installation:
- Fill and bleed hydraulic system Service and Repair
- Check pipe connections for leaks