4560 - P0087 (DDE)

4560 - P0087

Information saved in
DDE

Fault code
4560 - P0087

Fault text
DDE: Rail-pressure plausibility delivery-controlled: Positive
control deviation/rail pressure too low

Fault description
Monitoring for positive control deviation (rail pressure too
low) while rail pressure is being regulated by fuel-quantity
control valve.
The error is recognized when the positive control deviation
is greater than the limit defined by the operating point.
The limit is calculated based on engine rpm and lies between
170 bar and 200 bar.

Condition for fault identification
Test condition:
The test routine runs only when the following conditions are
satisfied:
- Rail-pressure control from fuel-quantity control valve is
active.
- Monitoring is enabled.
Voltage condition:
The test routine runs only when the following conditions are
satisfied:
- Rail-pressure control from fuel-quantity control valve is
active.
- Monitoring is enabled.

Condition for fault memory entry
Debounce (900 ms)

Action in service
Check the following potential problem sources:
- Fuel presupply pressure (low-pressure delivery circuit) is
too low (filter obstructed, leak in low-pressure circuit).
- Rail-pressure sensor indicates incorrect value.
- Leakage in high-pressure circuit.
- Injector is sticking open.
- Worn high-pressure pump.
- Worn injector.
- Internal leakage in common rail system.
- External leakage in common rail system.
- Air in common rail system.
Investigate potential problem sources, conduct rail-pressure
control system test.

Fault effect and breakdown warning
Output governed.
Proceed to the nearest BMW Service facility.

Driver information
Warning light:
MIL_SVS

Service instruction
none