3FD0

3FD0 - P0101

Information saved in
DDE

Fault code
3FD0 - P0101

Fault text
DDE: Air-mass flow sensor: No signal

Fault description
The diagnostic trouble code is logged in the ECU when the
load correction factor for the measured air mass exceeds the
approved limit 0.

Condition for fault identification
Test condition:
The test routine is executed continuously. However, a new
correction factor is calculated only once per driving cycle,
and provided that this function is enabled based on
environmental conditions and the current operating point.
Voltage condition:
The test routine is executed continuously. However, a new
correction factor is calculated only once per driving cycle,
and provided that this function is enabled based on
environmental conditions and the current operating point.

Condition for fault memory entry
No debouncing.None.

Action in service
Replace mass-airflow sensor.

Fault effect and breakdown warning
The error disables regeneration in the particulate filter.

Driver information
Warning light:
MIL

Service instruction
none