24 14 005 Replacing Sealing Cap For Selector Shaft (GA6L45R)

24 14 005 Replacing Sealing Cap For Selector Shaft (GA6L45R), Four-wheel Drive

Special tools required:







IMPORTANT:
After completion of work, check transmission oil level.
Use only the approved automatic transmission oil in this automatic transmission.

Failure to comply with this requirement will result in serious damage to the automatic transmission.







Necessary preliminary tasks:
- Remove rear underbody protection
- Remove front propeller shaft at transfer box and tie to one side.
Tasks are described in removing front propeller shaft.







Screw special tool 23 0 490 into sealing cap.
Drive out sealing cap using impact weight (1).

IMPORTANT:
Clean bore hole using a clean cloth and ensure that there is no more oil sticking to it.







Apply Loctite 380 either all-over (360°) at the sealing cap (1) or in the transmission bore hole (2).












Mount new sealing cap (1) onto drift (2).

NOTE: Drift (2) for driving in sealing cap is contained in repair kit.







Drive in new sealing cap (1) to the stop with drift (2).