24 13 014 Replacing Output Flange Radial Shaft Seal (GA6L45R)

24 13 014 - Replacing output flange shaft seal (GA6L45R) AWD





Special tools required:
- 24 4 320
- 24 4 330






Important!
After completion of work, check transmission fluid level 00 11 237 Checking/Topping Up Fluid Level In Automatic Transmission (GA6L45R).

Use only the approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Remove rear underbody protection
- Remove exhaust system.
- Remove heat shields
- Support transmission 24 00 032 Removing and Installing Automatic Transmission (GA6L45R)
- Remove transmission cross-member.
- Remove transfer box 27 10 010 Removing and Installing Transfer Case (ATC 300).





Mount special tool 24 4 320 and secure with hook wrench (1).

Screw in spindle (2) until radial shaft seal is released.





Installation Note:
Coat sealing lips of new radial seal with clean transmission oil.

Drive shaft seal firmly home with special tool 24 4 330.