51 14 110 Removing and installing/replacing rear model designation (Brilliance)

51 14 110 - Removing and installing/replacing rear model designation (Brilliance)





Important!
The "Instructions for number/letter combination cementing 51 14 ... Instructions For Attaching Number/Letter Designation Combination" serve as the basis for these repair instructions and must be followed without fail.





Attach adhesive tape (1) between edge of rear lid (3) and top edge measurement "A".
Mark measurement "B" from outer edge of rear lid on adhesive tape (1) and stick on adhesive tape (2) vertically.
Measurements E60:
A = - 18 mm
B = - 38 mm
Measurements E90:
A = - 25 mm
B = - 46 mm
Pull off liner (protective strip for adhesive surface).
Position characters on adhesive tapes (1 and 2) and stick into place.