24 13 014 Replacing Output Flange Radial Shaft Seal (GA6L45R)
24 13 014 Replacing output flange radial shaft seal (GA6L45R) AWDSpecial tools required:
Important!
After completion of work, check transmission oil level.
Use only the approved transmission fluid.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks:
^ Remove rear underbody protection
^ Remove exhaust system
^ Remove heat shields
^ Support transmission
^ Remove transmission crossmember.
^ Remove transfer box
Mount special tool 24 4 320 and secure with hook wrench (1).
Screw in spindle (2) until radial shaft seal is released.
Installation:
Coat sealing lips of new radial shaft seal with clean transmission oil.
Drive in radial shaft seal with special tool 24 4 330 until it stops.