54 10 175 Removing and Installing Rear Glass Slide/Tilt Sunroof Cover

54 10 175 Removing And Installing Rear Glass Slide/Tilt Sunroof Cover







NOTE:
- The following steps can be carried out inside the vehicle with the glass roof panel fully closed.
- Open floating roofliner fully.
- Make sure that grease at the ends of the rail do not come into contact with the roofliner.

Not necessary for replacement:
Before removing the Torx screws, make a mark around the washers in order to ensure correct alignment during installation.







Installation:
- Microencapsulated screws (Loctite) must be replaced and may not be reused
- Screw connection must be completed within 20 minutes (start of curing)
- Microencapsulated screws must not be retightened
- Clean thread of nut beforehand in event of repeated use







Release Torx screws (1).

IMPORTANT:
- Secure screws against falling out.
- If necessary, remove screw from guide rail.

Installation:
Insert new Torx screws with Loctite and align washers to markings.

Tightening torque 54 12 01AZ.







IMPORTANT: A second person is required to help in removing and installing the glass slide/tilt sunroof lid.

Lift out glass slide/tilt sunroof cover (1).

Installation:
Tape off complete edge area at roof aperture with fabric adhesive tape (risk of damage).

Install glass slide/tilt sunroof cover carefully (twist in) as seal can be damaged during installation.

Check glass slide/tilt sunroof cover for correct alignment and adjust if necessary.