With Idrive

Resetting the System

Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.






1. Press the "Menu" button. The start menu is opened.

2. "Vehicle Info"

3. "Vehicle status"






4. "Reset TPM"

5. Start the engine, but do not start driving.

6. Drive away. The tires are shown in gray and "Resetting TPM....." is displayed.

After driving a few minutes, the set inflation pressures in the tires are accepted as the target values to be monitored. The system reset is completed during your drive, and can be interrupted at any time. When driving resumes, the reset is continued automatically. On the Control Display, the tires are shown in green and "TPM active" is displayed again.

If a flat tire is detected while the system is resetting and determining the inflation pressures, all tire on the Control Display are displayed in yellow. The message "Low Tire!" is shown.