Replacing Sealing Sleeve for Transmission Housing (GA6HP26Z/6HP32Z)

24 34 020 - Replacing sealing sleeve for transmission housing (GA6HP26Z/6HP32Z)





Special tools required:
- 24 2 390 24 2 390 Covering Cap





Important!
After completion of work, check transmission oil level.

Use only approved transmission fluid.

Failure to comply with this requirement will result in serious damage to the automatic transmission!





Necessary preliminary tasks:
- Remove transmission cross-member.
- Remove transmission sump Service and Repair.

Important!
Support transmission with workshop hoist.





Unlock and disconnect plug (1) by turning.





Insert special tool 24 2 390 24 2 390 Covering Cap in sealing sleeve (1).





Unlock sealing sleeve with slide (1).





Note:
Note position of sealing sleeve.

Pull out sealing sleeve (1).

Installation Note:
Screw in sealing sleeve partially (lug in upper area). Turn until lug engages in groove of transmission. Slide in sealing sleeve.

Lug on sealing sleeve must not be damaged!