Suspension Control Module: Service and Repair

37 14 055 - Removing and installing/replacing DYNAMIC DRIVE control unit





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Disconnect battery negative lead Disconnecting and Connecting Battery Negative Lead
- Remove trim for instrument panel, bottom left 51 45 181 Removing and Installing/Replacing Bottom Right Trim For Instrument Panel
- Remove side trim in front right footwell Removing and Installing/Replacing Side Trim Panel, Footwell, on A-Pillar, Right





Disconnect plug connection (1).
Release nut (2) and nut (concealed) above control unit.
Tightening torque 37 14 24AZ Electric Components.
Pull out Dynamic Drive control unit towards bottom.





After installation:
- Replacement only: Carry out programming/coding Programming and Relearning
- Carry out steering angle sensor adjustment/adjustment for active front steering
- Only when replacing / programming / coding: Carry out initial DYNAMIC DRIVE operation Initial Inspection and Diagnostic Overview.