Replacing Power Steering Vane Pump

32 41 061 - Replacing power steering vane pump





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations





Necessary preliminary tasks:
- Remove vane pump





Release screws (1) and remove belt pulley (2).

Installation Note:
Lettering on belt pulley (2) points forwards.
Tightening torque 32 41 14AZ Pump and Oil Supply.





After installation:
- Fill and bleed hydraulic system
- Check pipe connections for leaks
- Version with Dynamic Drive: If necessary, carry out initial Dynamic Drive operation Initial Inspection and Diagnostic Overview