Power Steering Fluid Reservoir: Service and Repair

32 41 250 - Removing and installing/replacing fluid reservoir for power steering





Special tools required:
- 32 1 260 32 1 260 Pliers





Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.

Seal off pipe connections with plugs.





Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- M54, N52, N53, N54: Remove intake filter housing





Release screw (1).

Tightening torque 32 41 9AZ Pump and Oil Supply.

Note:
If necessary, raise and/or turn fluid reservoir in order to gain better access to hose clamps.

Remove hose clamps if necessary with special tool 32 1 260 32 1 260 Pliers.

Disconnect suction and cooler return lines from fluid reservoir, check and if necessary replace.

Lift out fluid reservoir.





After installation:

- Fill and bleed hydraulic system Service and Repair
- Check pipe connections for leaks