Rear

67 66 019 - Removing and installing/replacing drive unit for lumbar support on left or right rear seat (comfort seat)

Remove rear seat padding completely Removing and Installing Padding for Left or Right Rear Seat.





Remove plug connection (1) in direction of arrow and disconnect.
Cut through cable ties (2) on drive unit for lumbar support (3).

Installation:
Make sure cable ties (2) are correctly seated.





Detach hose (1) in direction of arrow.

Note:
If firmly seated, gently heat hose (1) on drive unit for lumbar support (2).

Installation:
Make sure hose (1) is laid without kinks.

Remove drive unit for lumbar support (2).

Replacement:
Pull drive unit for lumbar support (2) out of jacket (3).