Removing and Installing/Replacing Lower Section of Steering Spindle

32 31 070 - Removing and installing / replacing lower section of steering spindle





Important!
If the lower section of the steering spindle is separated from the power steering gear/steering column, this can result in damage to the steering column switch cluster when the steering wheel is turned!





Necessary preliminary tasks:
- Remove lower section of steering spindle from universal joint Replacing Universal Joint for Lower Section of Steering Spindle (do not pull out)
- Remove trim panel for pedal assembly 51 45 185 Removing and Installing/Replacing Panel For Pedals.





Remove air duct in footwell.
Mark installation position of lower section of steering spindle in relation to steering column.
Release clamping screw (1).
Return steering to straight-ahead drive setting and remove ignition key.
Pull lower section of steering spindle out of universal joint.
Detach lower section of steering spindle from steering column.

Installation Note:
Recut thread.
Replace clamping screw.
Clamping screw (1) must rest in groove of steering column.
Tightening torque 32 31 1AZ [1][2]Specifications.





After installation:
- Carry out steering angle sensor adjustment Adjustments
- Turn steering wheel in both directions to full lock
Note: The airbag warning lamp must not light up in the process.
- Check directional stability of car