Removing and Installing Complete Night Vision Camera

66 54 010 - Removing and installing complete night vision camera





Important!
Read and comply with notes on protection against electrostatic damage (ESD protection) 61 35 ... Notes on ESD Protection (Electro Static Discharge).





Necessary preliminary tasks:
- Remove front bumper trim
- Remove front underbody protection Removing and Installing/Replacing Front Underbody Protection
- Remove air duct for brake ventilation on left sides
- Partially remove cooling air duct
- Remove air duct (brake)





Unclip tube (1) from guide.
Disconnect associated plug connection.
Unscrew nuts (2).
Tightening torque 66 54 1AZ [1][2]Forward Looking Camera.





Release screws (1).
Tightening torque 66 54 1AZ [1][2]Forward Looking Camera.
Disconnect hose connection (2) and remove holder with night vision camera (3).





After installation:
- Fill up with washer fluid
Replacement only:
- Replace night vision camera Replacing Night Vision Camera
- Carry out coding/programming Programming and Relearning
- Adjust night vision camera Adjustments