Replacing Suction Line for Power Steering

32 41 311 - Replacing suction line for power steering (N62, N62TU)





Warning!
Danger of poisoning 00 .. ... Danger of Poisoning If Oil Is Ingested/Absorbed Through the Skin if oil is ingested/absorbed through the skin!
Risk of injury 00 .. ... Risk of Injury If Oil Comes Into Contact With Eyes and Skin if oil comes into contact with eyes and skin!

Important!
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Close off pipe connections with plugs.





Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations





Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove front underbody protection Removing and Installing/Replacing Front Underbody Protection
- Remove intake filter housing Service and Repair





Unfasten hose clip (1).
Detach suction line (2) from vane pump.

Installation Note:
Markings (3) on suction line and vane pump connection must match up.





If necessary, expose suction line up to connection on fluid reservoir.





Remove fluid reservoir bracket from body.
Unfasten hose clip (1).
Disconnect suction line (2) from fluid reservoir.

Installation Note:
Make sure suction line is laid without tension and with sufficient spacing to adjoining components.





After installation:
- Fill and bleed hydraulic system Bleeding Power Steering Unit
- Check pipe connections for leaks