Replacing Wiring Harness Section for Ignition Coil

12 51 100 - Replacing wiring harness section for ignition coil (N62, N62TU)





Necessary preliminary tasks:
- Read out fault memory of DME control unit; if necessary, work through test schedules
- Switch off ignition
- Remove right fresh air duct Service and Repair

Installation:
Make sure seal of wiring harness section for ignition coils is correctly installed in electronics box.





Unlock stopper (1) in direction of arrow.
Release screws.
Lift out cover (2).










Note:
Now clear the fault memory.