Removing and Installing / Replacing Servomotor for Right Eccentric Shaft (N62/N62TU)

11 37 024 - Removing and installing/replacing servomotor for right eccentric shaft (N62/N62TU)





Important!
Follow instructions issued by diagnosis tester.
Risk of damage to intermediate shaft.





(cylinder bank 1 to 4)

Necessary preliminary tasks:
- Connect diagnosis tester
- Remove acoustic cover
- Remove ignition coil cover





Important!
Follow instructions issued by diagnosis tester.

Unlock plug (1) on servomotor (2) and disconnect.





Unfasten screws.
Rotate servomotor (2) until no longer engaged in spline teeth of eccentric shaft.





Installation Note:
Replace sealing ring on spacer.
Install servomotor (1) and screw in up to spacer.
Rotate servomotor (1) into correct installation position.
Install and tighten down screws.





Installation Note:
Read out fault memory of control unit of Digital Motor Electronics (DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.