Removing and Installing/Replacing Drive Unit for Seat Height Adjustment

67 31 520 - Removing and installing/replacing drive unit for seat height adjustment





Necessary preliminary tasks:
- Remove front seat
- Remove outer cover on front seat Removing and Installing/Replacing Outer Cover on Left or Right Front Seat (Basic/Electric)





Set down front seat sideways on a suitable surface.
Disconnect plug connection (1).
Release screws (2).
Tightening torque 67 31 1AZ [1][2]Power Seat Motor.
Feed out drive unit for seat height adjustment (3) and remove.





Installation:
Fit drive unit for seat height adjustment (1) with plastic clip (2) only.
Make sure plastic clip (2) is correctly seated.





Replacement:
Initialize Programming and Relearning drive unit for seat height adjustment.