67 61 007 Removing and Installing/Replacing Drive with Gear (Rear) for Actuating Slide/Tilt Sunroof (Rear)

67 61 007 - Removing and installing/replacing drive with gear (rear) for actuating slide/tilt sunroof (rear)





Necessary preliminary tasks:
- Remove both trim panels for rear roof pillar Removing and Installing/Replacing Trim Panel for Rear Left or Right Roof Pillar (C-Pillar, Front) (C-pillars)
- Remove both trim panels for rear roof pillar (D-pillars)
- Remove both interior lights Removing and Installing/Replacing Left or Right Interior Light (Version With Panorama Glass Sunroof)
- Remove both rear grab handles 51 16 450 Removing and Installing/Replacing Rear Left/Right Grab Handle





Note:
Remove both rear and if necessary front counter supports for luggage compartment net.
Fold up cover (1).
Release screw (2) and remove counter support for luggage compartment net (3).





Pull off roofliner mucket in work area.

Important!
Do not under any circumstance kink roofliner (1).

Unclip and lower roofliner (1) in rear area.

Unfasten plug connection (2) and disconnect.

Note:
Secure drive with gear for actuating slide/tilt sunroof (4) against falling out.

Release screws (3), tightening torque 54 13 1AZ 54 13 Electric Components (of Sun Roof).

Note:
Screws (3) are microencapsulated.

Remove drive with gear for actuating slide/tilt sunroof (4).





Installation:
Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) exactly in gear teeth (3).





Installation:
- Initialize slide/tilt sunroof Testing and Inspection.