Replacing Output Flange on Transfer Case at Rear (ATC300)

27 10 070 - Replacing output flange on transfer case at rear (ATC300)





Important!
After completing work, check gear oil level Procedures and top up if necessary.
Use only the approved gear oil in this transfer case.





Note:
- Operations for removing output flange are identical to replacing radial shaft seal Replacing Radial Shaft Seal for Output Flange (ATC 300)

Installation Note:
- Thickness of new shim must be determined before output flange is installed





Determine and note down measurement A of output flange (previous and new).





Determine and note down measurement B of output flange (previous and new).





Determine measurement C, thickness of shim.





Installation Note:
Calculate thickness of new shim:
1. Add measurement A of output flange (previous) and measurement C of shim (previous)
Then subtract measurement B (previous) from result A+C (previous)
2. Subtract measurement B from measurement A of output flange (new)
3. Then subtract result of step 2 from result of step 1.